Two years or 12,500 cycles

Face of wall or between-jamb.

Push-up to 14′ wide and awning crank on larger sizes is standard (awning crank should be considered when doors are to be operated over a deep counter of over 7′ high). Chain hoist or motor operation are optional.

Interlocking type 17 flat slats are roll formed from 22 gage (galvanized steel)
(stainless steel) coil. With a single angle Bottom Bar.

Interlocking type 17 flat slats are roll formed from 22 gage (galvanized steel)
(stainless steel) coil. With a single angle Bottom Bar

Steel plate brackets are bolted to guides to support curtain and barrel and provide mounting for hood.

Steel pipe houses torsion spring assembly and supports curtain with a deflection of .03 inch per foot of width. Torsion springs are mounted on a continuous cold rolled steel shaft, adjustable by a tension wheel outside one bracket.

Square hood formed from 24 gauge (galvanized steel) (stainless steel) sheet, reinforced with tip and bottom flanges to limit deflection.

Slide Bolt locks standard for push-up operation, optional otherwise.

Galvanized steel slats and hoods are pre-finished with a baked on gray polyester primer before forming (Tan or bare available upon request). Steel footpiece, guides and brackets receive one coat of rust inhibiting color matching primer. Exposed stainless steel provided with #4 finish.